GLENWOOD

DOORS:

Shaker style door frames are made of solid beech, mortised and tenoned. The recessed plywood insert is three-ply with a rotary cut hard maple veneer. 

Solid Appalachian oak frames are joined by mortise and tenon. The flat plywood insert is a three-ply panel with a rotary cut red oak veneer face. 

WALL CABINETS:

FRAMES: All frames are built of solid ¾” oak, beech, or sycamore.
Each rail is kiln-dried, joined by mortise and tenon, and then glued
for added strength.

 END PANELS: End panels are wood veneered, ½” thick engineered
wood core plywood construction fastened to front frame with full ½”
tongue-in-groove to eliminate face nailing.

 BACKS: 1/8” hardboard recessed in sides.

 TOPS & BOTTOMS: 3/16” thick hardboard, dadoed into sides and
interlocked into hanging rails.

 HANGING RAILS: ¾” x 2 5/8” solid wood located at top and bottom.

 SHELVES: All wall cabinets feature adjustable shelves. A selection of six
different heights is built into each 30” high unit. On 2-door wall units,
the center 3” stile is used for center support of adjustable shelves. It is
recommended that a ¼” hole be drilled in the back for additional center
support. The extra shelf clip is provided. Shelves are ½” engineered
wood, with rounded front edge and printed wood grain.

 HARDWARE: Concealed self-closing hinges.

 FINISH: A 4-step process is applied to the exterior finish of Glenwood: Stain, Sealer, Sanding, and Catalyzed Top Coat.

BASE CABINETS:

FRAMES: All frames are built of solid ¾” oak, beech, or sycamore.
Each rail is kiln-dried, joined by mortise and tenon, and then glued
for added strength.

 END PANELS: End panels are wood veneered, ½” thick engineered
wood core plywood construction fastened to front frame with full
½” tongue-in-groove to eliminate face nailing.

 BACKS: 1/8” hardboard recessed in sides.

 BOTTOMS: 3/16” thick hardboard, dadoed into sides and
interlocked into hanging rails.

 HANGING RAILS: Solid wood, ¾” x 1½” located at top.

 CORNER BLOCK: Plastic corner block.
TOE KICK: ¾” pine.

 SHELF: ½” engineered wood 11” deep dadoed into sides, with
rounded front edge and printed wood grain.

 HARDWARE: Concealed self-closing hinges.

 DRAWERS: Plywood drawers are standard on both lines. “Four
sided captive” 7⁄16” birch 9-ply box with 1⁄8” birch 3-ply bottom.

 FINISH: A 4-step process is applied to the exterior finish of
Glenwood: Stain, Sealer, Sanding, and Catalyzed Top Coat.